0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 109 / 231
Truer Type
Input selection: DISC or ROLL
If you want to use a diamond roll to condition the grinding wheel then select ROLL.
If you want to use a diamond disc or single point diamond to condition the grinding wheel then select
DISC. Press the blue [Select] key on the HMI panel to toggle between DISC or ROLL.
PMHMI
Input selection: OFF or ON
Select if you are want to use the automatically generated dress program ACTIVEDRESS.SPF created
with the PMHMI application using the thread profile and tool data you selected in the [Thread Data]
screen.
Spindle Angle (used)
Input range: +/- 15°
Enter the grinding wheel helix angle that you want to use if you set PMHMI=OFF
Spindle Angle (PMHMI)
READ ONLY field
This field displays the grinding wheel helix angle calculated by PMHMI.
Probe Cycle
Input selection: OFF or ON
Select this function if you are want to use the probing system to automatically determine the pitch-in
position of the grinding wheel to the workpiece thread groove.
Barelling
Input selection: OFF or ON
Select this if you want to use the barrelling function (see section ?).
To Next Page
Loading...
