Matrix 0850 - Recovering from an Axis Software Travel Limit Condition

0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 228 / 231
Edition: 08/2013
23.4 Recovering from an axis software travel limit condition
The machine axes are factory configured with software position limits. If an axis has been
unexpectedly jogged onto its software position limit then you will see an alarm message displayed on
the machine HMI informing you of the axis which has reached its travel limit position.
Procedure
1. Select JOG mode at the machine control panel (MCP)
2. Select the axis that is on the software limit
3. If the axis is on the positive software limit then press the [-] jog button until the alarm
message disappears
4. If the axis is on the negative software limit then press the [+] jog button until the alarm
message disappears