Matrix 0850 - Explanation of Parameters

0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 176 / 231
Edition: 08/2013
19.22.3 Explanation of parameters
End-Thread Status
Input range: toggle ON/OFF
Zone specific end thread grinding ON/OFF
Thread Status
Input range: toggle ON/OFF
Zone specific thread grinding ON/OFF
Grind Mode
Input range: toggle 1-WAY or 2-WAY
1 = one-way grinding cycle
2 = two-way grinding cycle
No. of cycle
Input range: 0 - 99
This is the total number of grinding passes required in the zone
Workspeed
Input range: 1 – 99 rpm
Workpiece rotational speed
Grind Inc
Input range: 0 – 499 microns
Amount of stock to remove on diameter per grinding pass
Wheelspeed
Input range: 0 -70 M/sec
The grinding wheel surface speed during grinding