0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 163 / 231
19.18 Taper Correction
You can use the Taper Correction utility to remove unwanted stock found on the ground workpiece
after it has been measured. Taper correction is applied to the machine and remains active even
when a new workpiece is setup or loaded to the machine.
Scenarios where you might consider using the taper correction function:
1. parallel workpiece ground thread was measured and found to be showing a positive or
negative taper
2. taper workpiece ground thread was measured and found to be showing a positive or negative
taper
To Next Page
Loading...
