0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 166 / 231
19.18.4 Procedure
To add Taper Correction
1. Select [AUTO] and [SETUP] mode
2. Select the Correction utilities screen [Custom > Matrix > Main Menu > Setting Cycles >
Correction Utilities]
3. Select the [Taper Correction] softkey.
4. Input the measured taper error (mm/mm) followed by pressing the yellow [Input] key.
5. Press [Update Correction] vertical softkey
To reset the active Taper correction
Press the [Reset Correction] softkey.
To Next Page
Loading...
