0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 171 / 231
19.20.2 Procedure
To add Profile Correction
1. Select [AUTO] and [SETUP] mode
2. Select the Correction utilities screen [Custom > Matrix > Main Menu > Setting Cycles >
Correction Utilities]
3. Select the [Profile Correction] softkey.
4. Input the width and/or radial error (microns) followed by pressing the yellow [Input] key.
Diamond Width Error - Adjustment of the profile width (Input range: +/- 300 micron)
Diamond Radial Error – Adjustment of the profile height i.e the LH profile is offset with
respect to the RH profile (Input range: +/- 300 micron)
5. Press [Update Correction] vertical softkey
To reset the active Profile correction
Press the [Reset Correction] softkey.
To Next Page
Loading...
