0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 11 / 231
1.2 Understanding Safety Rules & Regulations
Understand and obey safety regulations set out by your employer. Read the operating instructions in
this and the CNC controller manuals.
1.3 Know your machine
An experienced operator will have knowledge of:
alignment and mounting of work pieces or devices
setting, operation and monitoring of the grinding machine
selection and use of abrasive products
recording of data for the machining of work pieces and optimisation of the machining process
special hazards and safety requirements
Observe all warning plates on the machine. Understand these warnings and follow their directions as
you operate the machine.
1.4 Maintain a safe working area
Your working area should be clean and uncluttered. Give yourself room for a firm, well balanced
stance.
Check all guards are in position and securely fastened
Be sure all guards are in correct position before operating the machine
Do not operate a machine with missing guards
Be sure that all fasteners are being used and they are firmly tightened.
Always wear safety glasses.
Always make sure that you have no loose clothing when working on the machine, especially
with the front door open and the axis moving, i.e. setting the part to run true with the C axis
rotating.
CAUTION
DO NOT open the wheel guard while the grinding wheel is rotating
DO NOT adjust the grinding coolant nozzles when the wheel is rotating
Be certain that the component is mounted securely and the driver is in place and secure.
Never try to stop a coasting grinding wheel with your hand or hand held object.
Stop coolant flow before stopping wheel.
DO NOT:
run coolant on a stationary wheel.
modify the drive to get higher wheel speeds.
use special pulleys, high speed motors or speed control devices which have been altered or
made inactive.
Use standard wheel dressers.
To Next Page
Loading...
