Matrix 0850 - Thread Parameter List

0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 118 / 231
Edition: 08/2013
19.4.2 Thread Parameter List
Parameter
symbol
range
units
Addendum Height
This is the height of the thread above the
effective diameter
a
mm
Left Hand Flank Correction
This parameter is an adjustment of the LH
side of flank from the nominal LH flank angle
deg
Righ Hand Flank Correction
deg
Dedendum Height
This is the height of the thread below the
effective diameter
d
mm
Name
This is the name of the thread profile
Pitch
P
mm
Left Hand Flank Angle
θ
1
deg
Right Hand Flank Angle
θ
2
deg
Effective Diameter
E
mm
Starts
Taper Rate
Number of Ribs
This is the number of ribs you want to put on
the grinding wheel with the same profile