0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 178 / 231
Total stock – for thread stock removal
READ ONLY field
Total amount of stock on diameter that will be removed from the workpiece after the grinding cycle
has completed.
Total stock – for end-thread stock removal
READ ONLY field
Total amount of stock on diameter that will be removed from the workpiece after the end-threading
cycle has completed.
19.22.4 End-threading parameters
End-Thread Status
Input range: toggle ON/OFF
Global end-threading function enable. If this parameter is set to OFF then the end-threading cycle
will not be performed on the workpiece.
Left Rotation
Input range: 0 - 540°
Amount of end-thread on LH side of workpiece
Right Rotation
Input range: 0 - 540°
Amount of end-thread on RH side of workpiece
Feed Override %
Input range: 1 - 100
Workspeed required for end-threading as a percentage of the thread grinding speed
Thread Grind
Input range: toggle ON/OFF
Global thread grinding function enable
If this parameter is set to OFF then the threading grinding cycle will not be performed on the
workpiece.
To Next Page
Loading...
