0850/0850-T1 User Manual
Matrix Machine Tool (Coventry) Limited 199 / 231
Oil Cooler cleaning procedure
1. Lift the air filter to remove it.
2. Use a vacuum cleaner, compressed air, water and brush to clean the filter. Allow the filter to
dry after cleaning before re-assembling. Clean once every 2 weeks with neutral detergent.
Cooling Coil - Clean cooling coil with a brush and avoid any knocks or shocks to the coil.
Oil Tank - Water can form between the tank and the sink at the bottom. Drain at least once a
month.
Oil Filter - Regularly clean the oil filter installed at the inlet point of the cooler unit. This will help
prevent any build up of cutting powder on the cooling coil.
Leakage - Leaks from the oil hose can be fixed by tightening the tube clips or replacing.
To Next Page
Loading...
