BIGFOOT GEAR HOUSING
90-857046R1 NOVEMBER 2001 Page 6B-17
5. Lift reverse gear, thrust bearing and thrust washer from bearing carrier. Replace thrust
bearing and thrust washer if rusted or damaged.
6. Replace reverse gear if gear teeth or clutch teeth on reverse gear are rounded or
chipped. If reverse gear must be replaced, pinion gear and sliding clutch should be in-
spected for damage.
19202
a
b
c
a- Reverse Gear
b- Thrust Bearing
c- Thrust Washer
7. If reverse gear radial bearing is rusted or does not roll freely, replace bearing. If the bear-
ing needs to be replaced remove it using Slide Hammer (91-34569A1).
19205
91-34569A1
a
a- Radial Bearing
To Next Page
Loading...
