Mitsubishi GOT1000 Series - Page 1003

24.4 Setting on Servo Amplifier Side
24.4.1 Connecting to the MELSERVO-J2-Super series
24 - 29
17
CONNECTION TO ALLEN-BRADLEY PLC
18
CONNECTION TO SIEMENS PLC
19
MICROCOMPUTER CONNECTION
20
CONNECTION TO OMRON TEMPERATURE CONTROLLER
21
CONNECTION TO YAMATAKE TEMPERATURE CONTROLLER
22
CONNECTION TO RKC TEMPERATURE CONTROLLER
23
CONNECTION TO FREQROL SERIES INVERTER
24
SERVO AMPLIFIER CONNECTION
(1) Parameter setting
Set the parameter at the pushbutton switch provided on the operation section of
the servo amplifier or setup software.
(2) When changing the parameter
Turn off then on the servo amplifier to be effective the new parameter.
MODE UP DOWN
SET
Pushbutton switch provided on
the operation section of the servo amplifie
r