Mitsubishi GOT1000 Series - Verifying GOT Recognizes Connected Equipment

3 - 32
3.3 Preparatory Procedure for Monitoring
3.3.6 Verifying GOT recognizes connected equipment
When changing communication interface setting by Utility
The communication interface setting can be changed by the Utility.
For details on the Utility, refer to the following manual.
GT User's Manual
2 The [Communication setting] appears.
3 Verify that the following communication
driver name is displayed in the box for
the communication interface to be used.
• Communication driver (either of the
following)
A/QnA/QCPU, QJ71C24
MELSEC-FX
4 When the communication driver name is
not displayed normally, carry out the
following procedure again.
Section 3.3 Preparatory
Procedure for Monitoring