A - 10
SAFETY PRECAUTIONS .................................................................................................................................A - 1
REVISIONS.......................................................................................................................................................A - 8
INTRODUCTION.............................................................................................................................................A - 10
CONTENTS ....................................................................................................................................................A - 10
ABOUT MANUALS .........................................................................................................................................A - 25
ABBREVIATIONS AND GENERIC TERMS IN THIS MANUAL......................................................................A - 26
HOW TO READ THIS MANUAL .....................................................................................................................A - 29
1. OVERVIEW 1 - 1 to 1 - 18
1.1 Connections and Functions Supported by GOT 1 - 4
1.2 Overall System Configurations 1 - 7
MITSUBISHI PLC CONNECTIONS
2. BUS CONNECTION 2 - 1 to 2 - 52
2.1 System Configuration 2 - 2
2.1.1 Connecting to QCPU (Q mode) ............................................................................................ 2 - 3
2.1.2 Connecting to QnACPU or AnCPU type............................................................................... 2 - 5
2.1.3 Connecting to QnASCPU or AnSCPU type .......................................................................... 2 - 8
2.1.4 Connecting to A0J2HCPU .................................................................................................. 2 - 14
2.1.5 Connecting to motion controller CPU (Q Series) ................................................................ 2 - 15
2.1.6 Connecting to motion controller CPU
(A273UCPU, A273UHCPU(-S3), A373UCPU(-S3)) ........................................................... 2 - 16
2.1.7 Connecting to motion controller CPU
(A171SHCPUN, A172SHCPUN, A173UHCPU(-S1)) ......................................................... 2 - 20
2.2 Preparatory Procedures for Monitoring 2 - 26
2.2.1 Installing OS onto GOT....................................................................................................... 2 - 27
2.2.2 Checking OS installation on GOT....................................................................................... 2 - 28
2.2.3 Setting communication interface (Communication settings)............................................... 2 - 29
2.2.4 Downloading project data ...................................................................................................2 - 36
2.2.5 Attaching communication unit and connecting cable.......................................................... 2 - 37
2.2.6 Verifying GOT recognizes connected equipment ............................................................... 2 - 39
2.2.7 Checking for normal monitoring.......................................................................................... 2 - 42
2.3 Precautions 2 - 44
2.4 Communication Check Sheet 2 - 51
INTRODUCTION
Thank you for choosing Mitsubishi Graphic Operation Terminal (Mitsubishi GOT).
Read this manual and make sure you understand the functions and performance of the GOT thoroughly
in advance to ensure correct use.
CONTENTS
To Next Page
Loading...
Need help?
General
