Mitsubishi GOT1000 Series - Setting Communication Interface (Communication Settings)

27 - 26
27.2 MELSECNET/10 Connection (PLC To PLC Network)
27.2.5 Setting communication interface (Communication settings)
27.2.5 Setting communication interface (Communication settings)
To configure the communication interface of the GOT, use the [Communication settings] of GT Designer2
and the switches of the communication unit.
Select the same communication driver as the one installed on the GOT for each communication interface.
For details on [Communication Settings] of GT Designer2, refer to the following manual.
GT Designer2 Version Screen Design Manual
1 Communication settings
1 Set "1" to the channel No. used.
2 Set the driver to "MELSECNET/10".
3 Perform the detailed settings for the driver. ( Communication detail settings)