18 - 10
18.3 Preparatory Procedures for Monitoring
18.3.3 Setting communication interface (Communication settings)
18.3.3 Setting communication interface (Communication settings)
Make the GOT communication interface settings on [Communication setting] of GT Designer2.
Select the same communication driver as the one installed on the GOT for each communication interface.
For details on [Communication setting] of GT Designer2, refer to the following manual.
GT Designer2 Version Screen Design Manual
1 Communication settings
1 Set "1" to the channel No. used.
2 Set the following in the driver box.
• When connectiong to SIEMENS S7-300/400 : SIEMENS S7-300/400.
• When connectiong to SIEMENS S7-200 : SIEMENS S7-200.
3 Perform the detailed settings for the driver. ( Communication detail settings)
To Next Page
Loading...
