28.3 Preparatory Procedures for Monitoring
28.3.6 Verifying GOT recognizes connected equipments
28 - 11
25
BAR CODE READER
CONNECTION
26
PRINTER CONNECTION
27
CNC CONNECTION
28
MULTI-CHANNEL
FUNCTION
29
FA TRANSPARENT
FUNCTION
30
MULTIPLE-GT11
CONNECTION FUNCTION
31
GATEWAY FUNCTION INDEX
When changing communication interface setting by Utility
The communication interface setting can be changed by the Utility.
For details on the Utility, refer to the following manual.
GT User's Manual
1 After powering up the GOT, touch [Main
Menu] [Communication setting] from
the Utility.
2 The [Communication setting] appears.
3 Verify that the following communication
driver name is displayed in the box for the
communication interface to be used.
• Communication driver
Bus (Q)
OMRON SYSMAC
OMRON THERMAC/INPANEL NEO
MELSERVO-J3,J2S/M
4 When the communication driver name is
not displayed normally, carry out the
following procedure again.
Section 28.3 Preparatory
Procedures for Monitoring
To Next Page
Loading...
