Mitsubishi GOT1000 Series User Manual

6.3 PLC Side Setting
6.3.3 Connecting to CC-Link module (A Series)
6 - 35
1
OVERVIEW
2
BUS CONNECTION
3
DIRECT CONNECTION TO CPU
4
COMPUTER LINK CONNECTION
5
MELSECNET/10 CONNECTION (PLC TO PLC NETWORK)
6
CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
7
CC-Link CONNECTION (Via G4)
8
ETHERNET CONNECTION
(3) Transmission speed setting switch
: Necessary : As necessary : Not necessary
*1 Specify the same transmission speed as that of the GOT.
(4) Condition setting switches
: Necessary : As necessary : Not necessary
*2 Will be valid when the CC-Link module is a local station.
In the case of the master station, turn off it.
When the switch setting has been changed
Turn the PLC CPU OFF then ON again, or reset the PLC CPU.
Transmission speed setting switch Description Setting Setting necessity at GOT connection
Transmission speed setting
(156kbps)
*1
0
Condition setting
switches
Setting switch Description Setting Setting necessity at GOT connection
SW1
Station type
(Master station / Local
station)
OFF (fixed)
SW2
Not used
OFF (fixed)
SW3
SW4
Input data status of the
data link error station
(clear)
OFF
SW5
Number of station setting
*2
OFF (fixed)
SW6
SW7 Not used OFF (fixed)
SW8
Module mode
(Intelligent mode)
OFF (fixed)
B RATE
0 156K
1 625K
22. 5M
35M
410M
0
1
9
8
7
6
5
4
3
2
12345678
O N
1
2
3
4
5
6
7
8
M / L
CLR
1/2
S. M
HLD
3/4
SW OFF ON
ISM
SFM
1/4 2/3

Mitsubishi GOT1000 Series Specifications

General

Power Supply	24 VDC
Type	HMI (Human Machine Interface)
Series	GOT1000
Resolution	640 x 480 pixels
Touch Panel Type	Resistive
Interface	RS-232, USB
Storage Temperature	-20 to 60°C
Protection Rating	IP65
Display Type	TFT LCD
Brightness	400 cd/m²
Backlight Life	50, 000 hours
CPU	RISC
Shock Resistance	147 m/s²
Display Size	10.4 inches