9.3 Preparatory Procedures for Monitoring
9.3.3 Setting communication interface (Communication settings)
9 - 27
9
CONNECTION TO
OMRON PLC
10
CONNECTION TO
KEYENCE PLC
11
CONNECTION TO
SHARP PLC
12
CONNECTION TO
TOSHIBA PLC
13
CONNECTION TO
HITACHI PLC
14
CONNECTION TO
MATSUSHITA PLC
15
CONNECTION TO
YASKAWA PLC
16
CONNECTION TO
YOKOGAWA PLC
2 Communication detail settings
(1) Communication interface setting by Utility
The communication interface setting can be changed on the Utility's
"Communication setting" after downloading "Communication setting" of project
data.
For details on the Utility, refer to the following manual.
GT User's Manual
(2) Precedence in communication settings
When settings are made by GT Designer or the Utility, the latest setting is
effective.
Item Description Range
Transmission Speed
Set this item when change the transmission speed used for com-
munication with the connected equipment.
<Default: 19200bps>
4800bps, 9600bps,
19200bps, 38400bps,
57600bps, 115200bps
Host Address
Specify the host address (station No. of the PLC to which the GOT
is connected) in the network of the GOT.
<Default: 0>
0 to 31
Delay Time
Set this item to adjust the transmission timing of the
communication request from the GOT.
<Default: 0>
0 to 300 ms
To Next Page
Loading...
Need help?
General
