9.4 PLC Side Setting
9.4.8 Connecting serial communication board (CS1W-SCB21, CS1W-SCB41)
9 - 53
9
CONNECTION TO
OMRON PLC
10
CONNECTION TO
KEYENCE PLC
11
CONNECTION TO
SHARP PLC
12
CONNECTION TO
TOSHIBA PLC
13
CONNECTION TO
HITACHI PLC
14
CONNECTION TO
MATSUSHITA PLC
15
CONNECTION TO
YASKAWA PLC
16
CONNECTION TO
YOKOGAWA PLC
2 Setting the DIP switches (CS1W-SCB41 only)
Set the DIP switches when performing the RS-422 communications on the CS1W-SCB41.
Remark
Precautions for changing the DM area
Before changing the DM area, make sure that the switch setting has been changed
as follows
CS1: Front panel DIP switch SW5 to "OFF"
DIP switch
Settings
Name Description
WIRE 2-wire/4-wire type switch 4 (4-wire type)
TERM Terminator ON/OFF switch 1 (no terminating resistor attached)
OFF
SCB41-V1
2
ON TERM
4 WIRE
PORT2
(RS422/
RS485)
RDY
COMM1
COMM2
TERM
WIRE
To Next Page
Loading...
