14.3 Preparatory Procedures for Monitoring
14.3.3 Setting communication interface (Communication settings)
14 - 27
9
CONNECTION TO
OMRON PLC
10
CONNECTION TO
KEYENCE PLC
11
CONNECTION TO
SHARP PLC
12
CONNECTION TO
TOSHIBA PLC
13
CONNECTION TO
HITACHI PLC
14
CONNECTION TO
MATSUSHITAI PLC
15
CONNECTION TO
YASKAWA PLC
16
CONNECTION TO
YOKOGAWA PLC
2 Communication detail settings
(1) Communication interface setting by Utility
The communication interface setting can be changed on the Utility's
"Communication setting" after downloading "Communication setting" of project
data.
For details on the Utility, refer to the following manual.
GT User's Manual
(2) Precedence in communication settings
When settings are made by GT Designer or the Utility, the latest setting is
effective.
Item Description Range
Transmission Speed
Set this item when change the transmission speed used for
communication with the connected equipment.
<Default: 9600bps>
4800bps, 9600bps,
19200bps, 38400bps
57600bps, 115200bps
Data Bit
Set this item when change the data length used for communication
with the connected equipment.
<Default: 8bit>
7bit/8bit
Retry
Set the number of retries to be performed when a communication
error occurs.
When receiving no response after retries, the communication times
out.
<Default: 0 time>
0 to 5 times
Host Address
Specify the host address (station No. of the PLC to which the GOT
is connected) in the network of the GOT.
<Default: 1>
1 to 31
To Next Page
Loading...
