20.3 Preparatory Procedures for Monitoring
20.3.6 Verifying GOT recognizes connected equipment
20 - 25
17
CONNECTION TO
ALLEN-BRADLEY PLC
18
CONNECTION TO
SIEMENS PLC
19
MICROCOMPUTER
CONNECTION
20
CONNECTION TO OMRON
TEMPERATURE
CONTROLLER
21
CONNECTION TO
YAMATAKE TEMPERATURE
CONTROLLER
22
CONNECTION TO RKC
TEMPERATURE
CONTROLLER
23
CONNECTION TO
FREQROL SERIES
INVERTER
24
SERVO AMPLIFIER
CONNECTION
When changing communication interface setting by Utility
The communication interface setting can be changed by the Utility.
For details on the Utility, refer to the following manual.
GT User's Manual
1 After powering up the GOT, touch [Main
Menu] [Communication setting] from
the Utility.
2 The [Communication setting] appears.
3 Verify that the following communication
driver name is displayed in the box for the
communication interface to be used.
•
Communication driver:
OMRON THERMAC/INPANEL NEO
4 When the communication driver name is
not displayed normally, carry out the
following procedure again.
Section 20.3 Preparatory
Procedures for Monitoring
To Next Page
Loading...
Need help?
General
