2.2 Preparatory Procedures for Monitoring
2.2.6 Verifying GOT recognizes connected equipment
2 - 41
1
OVERVIEW
2
BUS CONNECTION
3
DIRECT CONNECTION
TO CPU
4
COMPUTER LINK
CONNECTION
5
MELSECNET/10
CONNECTION (PLC TO
PLC NETWORK)
6
CC-Link CONNECTION
(INTELLIGENT DEVICE
STATION)
7
CC-Link CONNECTION
(Via G4)
8
ETHERNET
CONNECTION
When changing communication interface setting by Utility
The communication interface setting can be changed by the Utility.
For details on the Utility, refer to the following manual.
GT User's Manual
Section 2.4
Communication
Check Sheet
When you have verified in the Communication setting that the GOT recognizes the
connected equipment, mark the check sheet.
Unit selection (Communication module)
Check
To Next Page
Loading...
