NICE3000
new
User Manual
6 System Commissioning and Functions
- 139 -
F6-46 Bit8 = 0: The number of car calls is not limited. The elevator automatically exits the VIP
state in one of the following conditions:
It does not enter the car call running within 30s after each time stop.
It has executed all car calls.
There is no car call 30s after the elevator enters the VIP state.
The following part describes how to set the VIP oor and use the VIP function.
1. Parameter setting
Assume that it is a 20-oor elevator, and the 8th oor needs to be set as the VIP oor.
Function Code Parameter Name Setting Range Value Remarks
F6-00
Top oor of the
elevator
F6-01 to 40 20
These two parameters are used to set the
top oor and bottom oor of the elevator,
determined by the number of actually
installed leveling plates.
F6-01
Bottom oor of the
elevator
1 to F6-00 1
F6-12 VIP oor 0 to F6-00 8 Set the 8th oor as the VIP oor.
FE-32
Elevator function
selection 1
Bit9: VIP
function
Bit9 = 1 The VIP function is enabled.
F6-46
VIP function
selection
Bit8: Number
of VIP car calls
limited
-
Bit8 = 1: The elevator responds to only one
car call (the last one).
Bit8 = 0: The number of car calls is not
limited.
2. Method of enabling VIP
■VIP enabled by hall call at VIP oor
The elevator enters the VIP state only when there is a hall call (input by the up/down hall call button)
at the VIP oor. F6-46 Bit0 needs to be set.
Function Code Parameter Name Setting Range Value Remarks
F6-46
VIP function
selection
Bit0: VIP enabled by
hall call at VIP oor
Bit0 = 1
When there is a hall call at the VIP
oor, the elevator enters the VIP state.
â– VIP enabled by terminal
The elevator enters the VIP state when the terminal for VIP hall call becomes ON. In this mode, when
the terminal for VIP hall call becomes ON, the elevator directly runs to the VIP oor, automatically
opens the door and wait for passengers. The parameters to be set are described in the following
table.
To Next Page
Loading...
Need help?
General
