Monarch nice3000 User Manual

6 System Commissioning and Functions NICE3000
new
User Manual
- 138 -
6
◆
Elevator Lock
The elevator lock function is described as follows:
●
After responding to all car calls that have been registered, the elevator returns to the elevator
lock oor.
●
After arriving at the elevator lock oor, the elevator opens the door, and then closes the door and
stops automatic running.
●
After the door closes, the elevator closes the lamp and fan in the car, and cancels hall call
display.
Note that the preceding description is the default setting of the system, and certain actions can be modied
by setting the related parameters.
The input setting of the elevator lock function is as follows:
Generally, the elevator lock signal is input via the elevator lock switch on the HCB of any oor. If this
signal needs to be input via the MCB, perform parameter setting (takes input terminal Xd as an example)
according to the following table.
Function Code Parameter Name Value
F5-d Xd function selection
28: NO elevator lock signal
60: NC elevator lock signal
The other parameters related to the elevator lock function are listed in the following table.
Function Code Parameter Name Setting Range Default
F6-04 Elevator lock oor F6-01 to F6-00 1
F6-38 Elevator lock start time 00.00–23.59 00.00
F6-39 Elevator lock end time 00.00–23.59 00.00
F6-40 Program control selection 1 Bit5: Timed elevator lock 0
F6-41 Program control selection 2
Bit8: Elevator lock at door open
Bit9: Display available at elevator lock
Bit10: Elevator lock in the attendant state
0
F6-42 Program control selection 3 Bit5: Clearing calls immediately at elevator lock 0
◆
◆
VIP Function
The VIP function is described as follows:
●
After the VIP function is enabled, the elevator rst directly runs to the VIP oor and provides
services for VIP persons.
●
After entering the VIP state, the elevator clears current car calls and hall calls, and does not
respond to hall calls; door open or close needs to be controlled manually.
●
The VIP running times is set in F6-46 Bit8 .
F6-46 Bit8 = 1: The elevator responds to only one car call (the last one); after arriving at the oor
required by the car call, the elevator automatically exits the VIP state.

Monarch nice3000 Specifications

General

Brand	Monarch
Model	nice3000
Category	Controller
Language	English