Monarch nice3000 - Page 177

7 Function Code Table NICE3000
new
User Manual
- 176 -
7
Function
Code
Parameter Name Setting Range Default Unit Property Page
F6-40
Program control
selection 1
Bit0: Disability function
Bit1: Soft limit function
Bit2: JP16 input used as back
door selection
Bit3: JP16 input used as the back
door open signal
Bit4: Opening only one door of
opposite doors under manual
control
Bit5: Timed elevator lock
Bit6: Manual door
Bit9: Disabling reverse oor
number clear
Bit10: Displaying next arriving
oor number
Bit11: Responding to car calls rst
Bit12: Car call assisted command
in single door used as disability
function
Bit13: Folding command used as
disability function and back door
function
Bit14: Car call command folding
Bit15: JP20 used for switchover to
back door
0 -
★
221
F6-41
Program control
selection 2
Bit2: Inspection to stop due to
slow-down 1
Bit4: Buzzer tweet during door
open delay
Bit6: Cancelling door open delay
Bit8: Elevator lock at door open
Bit9: Display available at elevator
lock
Bit10: Elevator lock in the
attendant state
Bit11: Blinking at arrival (within
the time set in F6-47)
Bit12: Door re-open during door
open delay
Bit13: Door re-open after car call
of the present oor
0 -
★
223