8 Description of Function Codes NICE3000
new
User Manual
- 260 -
Bit Function Description Default
Bit14 Car call command folding
Function disabled: CN7 is used for front door calls or ordinary
calls, and CN8 is used for back door calls or disability calls.
Function enabled: For CN7 and CN8, inputs 1 to 16 are used for
front door calls or ordinary calls, and inputs 17 to 32 are used for
back door calls or disability calls.
0
Bit15
JP20 used for switchover to
back door
JP20 is used for input of switchover between the front door and
the back door.
0
â—†
F6-41 Program Control Selection 2
Function Code Parameter Name Setting Range Default Unit Property
F6-41
Program control selection 2 0–65535 0 -
★
F6-41 is used to select program control functions. Each bit of the function code denes a function, as
described in the following table.
If a bit is set to 1, the function indicated by this bit is enabled; if this bit is set to 0, the function is disabled.
For details on how to view and set this function code, see the descriptions in section 8.21.1.
The functions dened by the binary bits of F6-41 are described in the following table.
Bit Function Description Default
Bit0 Reserved - 0
Bit1 Reserved - 0
Bit2
Inspection to stop due to
slow-down 1
During inspection running, if the slow-down 1 acts, the system
decelerates to stop.
0
Bit3 Reserved - 0
Bit4
Buzzer tweet during door
open delay
The buzzer will tweet when the door open delay time set in Fb-
14 is reached.
0
Bit5 Reserved - 0
Bit6
Cancelling door open
delay
Door open delay is cancelled when the door open delay button
is pressed again.
0
Bit7 Reserved - 0
Bit8 Elevator lock at door open
In the elevator lock state, the elevator keeps the door open at
the elevator lock oor.
0
Bit9
Display available at
elevator lock
In the elevator lock state, hall calls are displayed normally. 0
Bit10
Elevator lock in the
attendant state
The elevator is locked properly in the attendant state. 0
Bit11 Blinking at arrival
The car display blinks when the elevator arrives at a oor. The
blinking advance time is set in F6-47.
0
Bit12
Door re-open during door
open delay
The door re-opens if the door open delay input is active during
door close.
0
Bit13
Door re-open after car call
of the present oor
The door re-opens if the car call of the present oor is valid
during door close.
0