Monarch nice3000 - Page 277

9 Troubleshooting NICE3000
new
User Manual
- 276 -
9
Fault
Code
Name Possible Causes Solution
Level
Err35
Shaft auto-
tuning data
abnormal
● Subcode 105: The
elevator running direction
and the pulse change are
inconsistent.
● Subcodes 106, 107, 109:
The plate pulse length
sensed at up/down
leveling is abnormal.
● Subcodes 108, 110: No
leveling signal is received
within 45s continuous
running.
● Subcodes 111, 115: The
stored oor height is
smaller than 50 cm.
● Subcode 112: The oor
when auto-tuning is
completed is not the top
oor.
(End)
Subcode 105:
Check whether the elevator running direction
is consistent with the pulse change in F4-
03: F4-03 increases in up direction and
decreases in down direction. If not, change
the value of F2-10 to ensure consistency.
Subcode 106, 107, 109:
● Check that NO/NC state of the leveling
sensor is set correctly.
● Check whether the leveling plates are
inserted properly and whether there is
strong power interference if the leveling
sensor signal blinks.
● Check whether the leveling plate is too
long for the asynchronous motor.
Subcodes 108, 110:
● Check whether wiring of the leveling
sensor is correct.
● Check whether the oor distance is too
large, causing running time-out. Increase
the speed set in F3-11 and perform shaft
auto-tuning again to ensure that learning
the oors can be completed within 45s.
Subcodes 111, 115:
Enable the super short oor function if the
oor distance is less than 50 cm. If the oor
distance is normal, check installation of the
leveling plate for this oor and check the
sensor.
Subcode 112:
Check whether the setting of F6-00 (Top oor
of the elevator) is smaller than the actual
condition.
(End)
4C