• In order to perform the Color Verify correctly, make sure to specify the following settings same as
the setting when the baseline was saved. If these settings are different, the color difference may
become large.
• Blower heater settings, Effect setting, CR Head Travel setting, Multi strike setting, Media thickness
correction setting, and Media feed compensation setting
• Since the room environment (temperature, humidity) may affect the print color, create the
environment in accordance with the environment condition described in the operating manual
"
8.1.1 Printer specifications" "Environment Condition". In addition, make sure to place the media
and ink in the printing environment for 2 hours before use.
• "Color Verify" is a function to check the color variation in print color caused by various causes.
This function is not to guarantee the color reproducibility.
• Since the judgment of color acceptance is largely dependent on the human eye, we recommend to
perform the print to check the color.
• The message "Update Result?" is displayed on the operation panel.
23. Press [Enter] key to save the measurement value of the currently printed color patches.
• When the measurement value is saved, the baseline will be replaced by the currently measured
value.
• Press [Cancel] key to not to save the measurement value.
• "Ready to Print" is displayed on the operation panel.
To Next Page
Loading...
Need help?
General