Maintenance VJ-1617H OPERATION MANUAL
6-24
6.3.2 Recovery procedure for the printer after long storage
The printer after long storage has the cleaning liquid inside before Sleep mode started or the printer was
turned OFF. Therefore, the recovery operation is required before printing.
• When you have had the printer OFF for a long time:
You need to perform the initial ink filling as a recovery operation.
6.3.2.1 Recovery procedure for the printer after long storage (when the printer was turned OFF)
• When you did not use the printer for more than one week in Sleep mode when using 5-color set:
Replace the cleaning ink in some of the ink tubes with ink as a recovery operation.
6.3.2.2 Recovery procedure for the printer after long storage (for sleep mode for 5-color set)
6.3.2.1 Recovery procedure for the printer after long storage (when the printer
was turned OFF)
If you have had the printer OFF or had it in Sleep mode for a long time, the cleaning liquid is filled from
the "Long storage" menu. Perform initial charge before printing. Because cleaning using the cleaning
liquid is not required, the procedure is partially different from "3.4 Initial ink filling".
Follow the procedure below to perform initial ink filling at the time of recovery.
1. Turn the printer ON.
3.2.1 Turning the power ON
• The printer starts the initial operation.
• After the initial operation is complete, "Start Ink Charge E" is displayed on Operation panel.
2. Press the [Enter] key on Operation panel.
• "Wash Retry? Yes" is displayed on Operation panel.
3. Use the [+] or [-] key on Operation panel to select "Wash retry? No".
To Next Page
Loading...
Need help?
General