•Head cleaning can be operated when the printer is Normal.
Refer to the following for operation procedures.
6.5.3 Head cleaning
Setup item Description
Short Discharges smaller amount of ink compare to "Normal".
• [Enter] key: "Cleaning **%" is displayed on the operation panel and Head cleaning starts.
Progress on the Head cleaning is displayed in % on the operation panel.
Normal Select this mode normally.
• [Enter] key: "Cleaning **%" is displayed on the operation panel and Head cleaning starts.
Progress on the Head cleaning is displayed in % on the operation panel.
Long Discharges larger amount of ink compare to "Normal".
Used when the print head does not improve by normal Head cleaning.
• [Enter] key: "Cleaning **%" is displayed on the operation panel and Head cleaning starts.
Progress on the Head cleaning is displayed in % on the operation panel.
Little charge Refills a small amount of ink.
• Consumes a lot larger amount of ink than "Strong".
• The cleaning effect is much higher than "Strong".
• [Enter] key: "Ink Refill **%" is displayed on Operation panel and ink replenishment starts.
Progress on Little charge is displayed in % on Operation panel.
Replacing ink Initial ink charge
• Performs the initial ink charge.
• Consumes a lot larger amount of ink than "Little charge".
• The cleaning effect is much higher than "Little charge".
• [Enter] key: "Ink Refill **%" is displayed on Operation panel and initial ink charge starts.
Progress on the initial ink charge is displayed in % on Operation panel.
— • [Cancel] key: shifts to the previous menu.
5 Panel setup menu
To Next Page
Loading...
Need help?
General