VJ-1617H OPERATION MANUAL Maintenance
6-7
a. To set the printer status to sleep mode, follow the procedure below.
3.3.1 Set sleep mode on the printer
b. To power off the printer, follow the procedure below.
3.2.2 Turning the power OFF
• "CR Mainte.: Start" is displayed on the operation panel.
3. Press the [Enter] key on the operation panel.
• Maintenance starts.
• The print head moves to the left.
• The cleaning wiper raises.
• "CR Maintenance: End" is displayed on the operation panel.
4. Clean the cleaning wiper unit.
6.2.1 Cleaning the cleaning wiper unit
5. Clean around the print head.
6.2.2 Cleaning around the print head
•Press the [Cancel] key if Daily maintenance is not performed.
6. After cleaning is completed, press the [Enter] key on the operation panel.
• The cleaning wiper returns to its original position.
• The print head returns to its original position.
• The printer goes into Sleep mode or turns the power OFF.
7. After cleaning, leave the cleaning stick in the cleaning fluid to store.
• Replace the cleaning stick every week.
• Do not use a cleaning stick that has dried ink on it.
• Make sure to cover the plastic cup that has cleaning fluid with a plastic bag or wrap to avoid dust
for storing.
• Replace the cleaning fluid poured into the plastic cup every week.
6.2.1 Cleaning the cleaning wiper unit
This sub-section describes how to clean the cleaning wiper and surrounding area.
Follow the procedure below to clean the cleaning wiper and the surrounding area.
To Next Page
Loading...
Need help?
General