Handling the printer VJ-1617H OPERATION MANUAL
4-2
4.1 Print flow chart
The following flow chart illustrates the procedure to perform printing with the printer.
Refer to each section as required.
• Do not put combustible materials on the platen or media guide while performing the
heater operation.
It could lead to fire.
• Do not spill flammable liquid over the platen or media guide.
This could lead to fire.
• Before performing work, make sure to read the material safety data sheet (MSDS).
• Keep the work area well-ventilated.
This prevents fire, and stops operators from feeling sick from bad air.
1. Create print data.
Create print data with application software.

2. Turn Blower heater ON and make settings.
4.5 Using Blower heater

3. Turn the printer ON, and shake the ink packs.
3.5 Setting media

4. Load the media.
4.2 Media

5. Perform Media feed compensation.
4.2.7 Media feed compensation

6. Set up printing conditions.
4.3 Menu setups on the operation panel

7. Perform the printing.
4.4 Operating from the operation panel
To Next Page
Loading...
Need help?
General