• "***" in the error message is the code no. that indicates what type of error occurred.
• The command code representing the error occurred may be indicated in [ ].
• For the settings on your PC side, refer to the Operating Manual attached with your PC.
7.2.5 Error requiring restart
This section describes errors requiring restart and remedies.
An error requiring restart is displayed if a fatal operational failure such as the following occurs.
• When an obstacle that prevents printing occurs
• When a problem occurs with the electrical circuit (PCB, motor, sensor, etc.) of the printer
• When a failure in the printer control program occurs
If an error requiring restart occurs, the printer stops operating after performing the following operations.
1. The drive power automatically shuts down.
2. All lamps on the operation panel blink, and the buzzer rings continuously.
3. The error message is displayed on the operation panel.
Pressing any key on the operation panel stops the beeping.
For an error requiring restart, operation will return to normal after removing the cause of the error and
restarting the printer.
If the same error continues to be displayed, contact the your local MUTOH dealer.
Be sure to tell us the code no. of the error message when you contact us.
When "E153 Err FLBOX Height" is displayed on the operation panel, follow the procedure below
to recover the error.
7.4 Recovering the flushing box height error
No. Display Description Remedy Reference
1 E** Error [ ] A problem that does not have
a remedy has occurred.
1. Remove obstacles such as
paper scraps in the drive
system.
7.3 The
media is jammed
2. Confirm that the replaced
items are correctly attached.
6.4 Replacin
g consumable
components
3. Turn OFF the printer
power, and turn it ON again
after 10 seconds or longer.
To Next Page
Loading...
Need help?
General