• Performing printing if the printer is connected to PC, the print settings of RIP soft you are using are
printed on “data header.
5.3.18 Initialization menu
Returns the settings of the printer to default.
Use this if you enter a wrong setting value by mistake, or if you want to set the value back to the default.
Setup item Setting Description
<Off> • Prints only the data to be ptinted.
• Dump data is not printed.
On Dump data is printed after the original image is printed.
Dump • Prints only damp data. “Data dot number” is not printed.
• The original image is not printed.
— • [Cancel] key: shifts to the previous menu without
initialization.
5.3 Setup menu
Setup item Setting Description
Initialization ALL All settings can be returned to factory default.
Setting menu The setting of the Setup menu is returned to factory default.
— • [Enter] key:
"Initializing" is displayed on the operation panel and the
printer initializes the setting.
• [Cancel] key: shifts to the previous menu without
initialization.
5.3 Setup menu
To Next Page
Loading...
Need help?
General