• During Sleep Mode, even if the set amount of time has passed, print-head cleaning is not performed
under the following circumstances.
• Front cover or Maintenance cover is open.
• Front media loading lever is raised (Rear media loading lever is lowered).
• The waste fluid tank is full.
• There is little remaining ink in the ink pack (or no ink).
• The ink bag has been removed.
• The inserted ink bag is not the genuine ink bag, etc.
When the printer returns to a normal state, head cleaning is restarted, and Sleep Mode continues.
7.2 Error messages
• If one of the above conditions occurs during head cleaning, cleaning is stopped.
When the printer returns to a normal state, head cleaning is restarted.
7.2 Error messages
5.1.2 Sleep Mode Start menu
Activate Sleep Mode
• CR maintenance starts before the printer goes into sleep mode; perform daily maintenance after the
operation.
6.2 Daily maintenance
• During Sleep Mode, "Press Enter to restart" will be displayed in the operation panel.
During Sleep Mode, pressing [Enter] key will return the printer to normal operation.
• Make sure you perform daily maintenance. If the printer goes into Sleep mode or the
power is turned OFF without daily maintenance, nozzles may get clogged.
Setup item Setting Description
Set Timer <Off> • Off:
• When the set time has elapsed, the head cleaning starts.
24 hours
48 hours
— • [Cancel] key: shifts to the previous menu.
5.1 Sleep mode menu
To Next Page
Loading...
Need help?
General