• When the [Cancel] key is pressed in "CR mainte.: Start" screen, the printer does not shift to CR
maintenance and shifts straight to Sleep mode.
• If the printer is under one of the following conditions while shifting to the Sleep Mode, "Don’t Start
Sleep Mode" is displayed, and will not shift to the Sleep Mode.
• Front cover or Maintenance cover is open.
• Front media loading lever is raised (Rear media loading lever is lowered).
• The waste fluid tank is full.
• There is little remaining ink in the ink pack (or no ink)
• The ink bag has been removed.
• The inserted ink bag is not the genuine ink bag, etc.
Activate Sleep Mode again after returning the printer to a normal state.
7.2 Error messages
• If the printer is under one of the conditions above during the Sleep mode, the printer will not return
to the Normal condition even pressing the "Enter" key.
Return the printer to a normal state, and press [Enter] key to return the printer to normal operation.
7.2 Error messages
Setup item Setting Description
Start — • [Enter] key:
To Next Page
Loading...
Need help?
General