MUTOH vj-1617h - Standby Heating Menu; Head Travel Menu

VJ-1617H OPERATION MANUAL Panel setup menu
5-31
5.3.6 Standby Heating menu
Sets up the length of time to preheat the heater while the printer is in standby mode.
If printing again during the set time of standby heat, warm-up time can be shortened.
NOTE
• The Standby heating function is only available when Blower heater is in the "Printer Link" status.
5.3.7 Head Travel menu
Sets up the range that Print head moves while printing.
Setup item Setting Description
StandbyHeating 10 min to <60 min> 2hours/
3hours/4hours
Sets the length of time to preheat the heaters.
When more than the set time has passed, each heater turns off.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.2 User Type menu
Setup item Setting Description
CR Movement Data Print head moves the range of the print data width.
The printing speed will be improved since the moving range
of Print head is optimized.
Machine Print head moves from origin to the maximum printable media
width.
<MediaWidth> Print head shifts within the media width.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.3 Setup menu