MUTOH vj-1617h - Printing-Related Troubleshooting

VJ-1617H OPERATION MANUAL Troubleshooting
7-7
7.1.4 Printing-related troubleshooting
(1) Printing is partially stained or incomplete
NOTE
• Proper print quality may not be obtained with the media other than the recommended one.
(2) The printing position is incorrect (some parts of the media cannot be printed
on)
(3) Printing is blurred
No. Possible cause Remedy Reference
1 Does the media include moisture? Replace it with new media.
6.4.3 Replaci
ng roll media
2 Are you using the folded or wrinkled media?
3 Does the media bend? Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
4.2.1 Loadab
le media
5.2.2.4 Vacu
um Fan menu
No. Possible cause Remedy Reference
1 Is the loading position of the media correct? Set the media correctly.
3.5.5 Setting
roll media
2 Did you set up the origin and print position? Cancel or reset the settings of the origin and
print position.
5 Panel
setup menu
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Loadab
le media
2 Are you using the thick or thin media? Use the recommended media.
4.2.1 Loadab
le media
3 Is the media printed on the printing surface? Confirm the printing surface of the media and
set it correctly.
3.5 Setting
media
4 Did you perform Alignment? Perform Alignment.
3.7 Adjust
print
5 Did you perform Media feed compensation? Perform Media feed compensation.
4.2.7 Media
feed
compensation
6 Is the heater temperature setting appropriate? Set it to the appropriate temperature.
4.5.4 Adjusti
ng Heater output
and air volume