Safety instructions VJ-1617H OPERATION MANUAL
1-4
Use a power cord set which is equipped with a protective earth, and securely connect it to the outlet.
Make sure to use only the specified power supply (AC 100 V to 120 V or AC 220 V to 240 V).
If a power supply other than the specified voltage is used, it could cause an electric shock and fire.
Take power for the printer directly from the power socket (AC 100 V - 120 V or AC 220 V - 240 V).
Do not use multiple plugs on the same socket.
This could generate heat and might cause fire.
Be sure to use a dedicated power socket with earth wire for the power supply, and connect it to the earth wire.
If the earth wire is not connected, an electric shock or fire may occur.
The waste fluid from the printer is industrial waste.
Proper waste fluid disposal according to industrial waste disposal laws and ordinances of your local government
is required.
Consign disposal of waste fluids to a specialized processor.
Pay attention to the following points when handling power cable.
•Do not tamper with the power cable.
•Do not put heavy objects on the power cable.
•Do not bend, twist or pull the power cable by force.
•Do not route the power cable near heating appliances.
Pay attention to the following points when handling the power supply plug.
Any mishandling of the power cable could cause a fire.
•Make sure that no foreign substances such as dust etc. are stuck to the power plug.
•Make sure that the power plug is firmly inserted to the edge of the power socket.
When handling ink bags, pay attention so that ink does not get into your eyes or stick to your skin.
If ink gets into your eyes or sticks to your skin, immediately wash it off with water.
Failing to do so might cause irritation or light inflammation of eyes.
In case of any abnormality, consult a physician immediately.
Do not disassemble the ink bags.
If disassembled, there is a possibility that ink might come into contact with eyes or skin.
Do not operate the media loading lever during initial operation and printing.
The print head portion may touch the pressurizing roller portion, and cause a malfunction.
Do not use volatile solvents such as thinner, benzene, or alcohol.
These solvents could cause damage to the paint.
Be careful that no moisture enters the printer.
There is a possibility that the electric circuit inside the printer is short circuited.
Do not open covers attached using screws under any circumstances.
This may cause an electric shock or a malfunction.
Do not drop waste fluid when replacing the flushing-box sponges.
If waste fluid comes into contact with the grid roller, the surface of the grid roller will be damaged, and the media
feed function may be affected.
To Next Page
Loading...
Need help?
General