Before using VJ-1617H OPERATION MANUAL
3-18
• The timer has been set.
• "Sleep Mode1: Timer Set" is displayed on Operation panel.
7. Use the [+] or [-] key on Operation panel to select "Sleep Mode2: Start".
• "Start Sleep Mode?" is displayed on Operation panel.
8. Press the [Enter] key on Operation panel.
• "CR Mainte.: Start" is displayed on Operation panel.
• If you press the [Cancel] key on Operation panel at this point, you can skip the next procedure and
turn OFF the printer. If you have already performed daily maintenance, you can skip the operation.
• Make sure you perform daily maintenance. If the printer goes into Sleep mode or the
power is turned OFF without daily maintenance, nozzles may get clogged.
9. Press the [Enter] key on Operation panel.