NETGEAR ProSAFE WC7500 User Manual

Configure the System and Network Settings and Register the Licenses
105
ProSAFE Wireless Controller
6. Click the Apply button.
Your settings are saved.
Setting Description
IP Settings section
IP Address Enter the IP address of the wireless controller.
The default IP address is 192.168.0.250. To change it, enter an available IP
address from the address range used on your LAN.
Note: If you assign a static IP address to the wireless controller and then use the
web management interface of a discovered access point to configure a static IP
address for the access point and enter the wireless controller’s static IP address,
the access point attempts to reach the wireless controller only at the provided static
IP address.
If the IP address of the wireless controller changes, the access point can no longer
reach the wireless controller. In such a situation, reset the access point to factory
default settings. Doing so removes the static IP address of the wireless controller
from the access point configuration.
IP Subnet Mask Enter the subnet mask value used on your LAN.
The default value is 255.255.255.0.
Default Gateway Enter the IP address of the gateway for your LAN.
Primary DNS Server Enter the IP address of the primary Domain Name Server (DNS) that you want to
use.
Secondary DNS Server Enter the IP address of the secondary DNS that you want to use.
WINS Server Enter the IP address of the Windows Internet Name Service (WINS) that you want
to use.
Management VLAN Settings section
Management VLAN Enter the management VLAN.
For more information, see Management VLAN Concepts on page 102.
Untagged VLAN Select the Untagged VLAN check box if the configured VLAN is untagged.
For more information, see Untagged VLAN Concepts on page 103.
10G Port Settings section
1
1. Link aggregation is not supported on model WC7500 and model WC7600v2.
LAG Select the LAG radio button to enable the wireless controller to automatically
create a LAG in which both links are active.
The LAG radio button and Active Standby radio button are mutually exclusive.
For more information, see Controller Link Aggregation Concepts on page 103.
Active Standby Select the Active Standby radio button to enable the wireless controller to
automatically create a LAG in which only one link is active and the other link
functions as a standby link.
The Active Standby radio button and LAG radio button are mutually exclusive.
For more information, see Controller Link Aggregation Concepts on page 103.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English