NETGEAR ProSAFE WC7500 User Manual

Discover and Manage Access Points
167
ProSAFE Wireless Controller
After the access points are added to the Managed AP List, the wireless controller
upgrades the firmware of the access points to the latest firmware that is loaded on the
wireless controller, and the access points become managed access points. Depending
on the number of access points that you add to the Managed AP List, this process might
take several minutes.
By default, the access point upgrade process uses multicast. If you must configure a
specific multicast IP address range for the upgrade process or disable multicast, see
Configure Multicast Firmware Upgrade for Access Points on page 278.
If one or more access points do not transition to the Connected state (see the Status
column in the Managed AP List), see Resolve Problems With Access Points on
page 365.
For information about how to manage the Managed AP List, see Manage the Managed
AP List on page 167.
Manage the Managed AP List
After you add discovered access points to the Managed AP List, you can view the status of
the access points on the list, change information for selected access point on the list, and
remove access points from the list.
View the Managed AP List
The managed AP List displays the status, IP addresses, MAC addresses, model numbers,
names, and other information for the managed access points.
 To view the status and other information for managed access points:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English