NETGEAR ProSAFE WC7500 User Manual

Maintain the Wireless Controller and Access Points
277
ProSAFE Wireless Controller
Reboot Access Points
Under normal circumstances, you do not need to reboot an access point. If a problem occurs
with an access point, you can reboot it to see if this resolves the problem.
 To reboot an access point:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Select Maintenance > Reboot/Reset > Access Points.
5. To find the access point that you want to reboot, in the Search field, enter the IP address,
MAC address, model, or name of the access point, or enter other information to narrow
down the information that is displayed in the table.
The table displays only the access point or access points that match the information that
you entered in the Search field.
6. Take one of the following actions:
• Select a single access point by selecting the check box to the right of the access
point.
• Make a selection of access points by selecting the check boxes to the right of the
access points.
• Select all access points by selecting the check box in the upper right of the table
heading.
7. Click the Reboot button.
The selected access point or access points are rebooted.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English