NETGEAR ProSAFE WC7500 User Manual

Configure WiFi and QoS Settings
215
ProSAFE Wireless Controller
7. For each profile on a WiFi radio in the selected profile group, specify the rate limit as a
percentage.
You can drag the sliders to adjust the values in the Rate Limit fields to the right of the
sliders. Make sure that the total percentages of all profiles on one WiFi radio in the
selected profile group do not exceed 100 percent.
8. Click the Apply button.
Your settings are saved.
Manage the LED Behavior
Note: This feature is supported for access point models WN370, WAC720,
WAC730, and WAC740 only.
You can manage the LED behavior of WN370, WAC720, WAC730, and WAC740 access
points by enabling all LEDs (which is the default setting), by enabling the Power LED only, or
by disabling all LEDs. You can configure a different setting for each model access point that
supports management of the LED behavior.
This feature is useful if an access point is installed in a hotel guest room and you want to
make sure that guests are not disturbed by the blue light of the LEDs.
Manage the LED Behavior for the Basic Profile Group
You can manage the LED behavior of WN370, WAC720, WAC730, and WAC740 access
points that support the basic profile group.
 To manage the LED behavior of WN370, WAC720, WAC730, or WAC740 access points
that support the basic profile group:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Select Configuration > Profile > Basic > AP LED State.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English