Configure WiFi and QoS Settings
193
ProSAFE Wireless Controller
Override Channel and Transmission Power in an Advanced
Profile Group
The table on the Advanced Wireless Settings page shows the access points that are
managed in the profiles of an advanced profile group and to which the channel allocation and
advanced RF management settings apply.
After you configure the WiFi settings for an advanced profile group (see Configure WiFi
Settings for an Advanced Profile Group on page 188), you can change the channel, the
transmission power, or both for individual access points in an advanced profile group.
For you to be able to configure these settings in the table, two requirements exist:
• Channel. To enable the Access Point Channel menu in the table, you must disable
automatic channel allocation on the Channel Allocation page (see Configure Channels on
page 195).
• Transmission power. To enable the Tx Power menu in the table, you must disable
automatic Tx power control on the advanced RF Management page (see Configure
Radio Frequency Management for an Advanced Profile Group on page 200).
 To override the channel and transmission power for individual access points in a
security profile of an advanced profile group:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Select Configuration > Wireless > Advanced > Wireless.
To Next Page
Loading...
Need help?
General
