NETGEAR ProSAFE WC7500 User Manual

Maintain the Wireless Controller and Access Points
263
ProSAFE Wireless Controller
5. Enable SNMP and configure the settings as described in the following table.
6. Click the Apply button.
Your settings are saved.
Specify Session Time-Outs
If an HTTP session times out, the user is redirected to the login page for password
verification.
Setting Description
SNMP Select the SNMP check box to enable SNMP for the wireless controller.
Read-Only Community Name Enter the community string that allows the SNMP manager to read the
wireless controller’s MIB objects.
The default setting is public.
Read-Write Community Name Enter the community string that allows the SNMP manager to read and
write the wireless controller’s MIB objects.
The default setting is private.
Trap Community Name Enter the community name that is associated with the IP address to
receive traps.
The default setting is trap.
IP Address to Receive Traps Enter the IP address at which the SNMP manager receives traps sent from
the wireless controller.
Trap Port Enter the port on which the SNMP manager receives traps sent from the
wireless controller.
The default setting is port 162.
SNMP Manager IP Enter the IP address of the SNMP manager.
To allow any SNMP manager to access the wireless controller, keep this
field blank.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English