NETGEAR ProSAFE WC7500 User Manual

Configure WiFi and QoS Settings
199
ProSAFE Wireless Controller
Configure Radio Frequency Management for the Basic Profile
Group
You can configure the WiFi transmission power, WLAN healing, and band steering for the
basic profile group.
 To configure RF management for access points in the basic profile group:
1. Open a web browser, and in the browser’s address field, type the wireless controller’s IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller’s login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller’s web management interface opens and displays the Summary
page.
4. Select Configuration > Wireless > Basic > RF Management.
5. Configure the settings as described in the following table.
Setting Description
TX Power Settings
Default Tx Power Make a selection from the menu to specify how the transmission (Tx)
power is configured on the access points: Full, Half, Quarter, Eighth,
or Minimum. By default, the selection from the menu is Half.
When automatic Tx power control is enabled, the selection from the
menu is used as the initial power level for the access points.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English