Manage Stacking and Redundancy
306
ProSAFE Wireless Controller
6. Configure the settings as described in the following table.
7. Click the Apply button.
Your settings are saved. The Secondary IP field displays the IP address of the redundant
controller (that is, the secondary controller).
Remove a Redundancy Group
You can remove an existing redundancy group. In a 1:1 redundancy group, the primary
controller is returned to a standalone configuration without redundancy. In a N:1 redundancy
group, the primary controllers are returned to a stacked configuration without redundancy.
After you remove a redundant controller, reset the redundant controller to its factory default
configuration before you use the controller in another configuration.
Setting Description
Controller IP Enter the IP address of the redundant controller. This is the address that you use to
log in to the redundant controller’s web management interface.
UserName The user name is a nonconfigurable field that displays the user name with which you
log in to the web management interface of the redundant controller. By default, the
user name is admin.
Password Enter the password with which you log in to the web management interface of the
redundant controller. If you did not yet personalize the password, enter password for
the password.
To Next Page
Loading...
Need help?
General
