NETGEAR ProSAFE WC7500 User Manual

Configure the System and Network Settings and Register the Licenses
117
ProSAFE Wireless Controller
5. In the Syslog Settings section of the page, configure the settings as described in the
following table.
6. Click the Apply button.
Your settings are saved.
Setting Description
Enable Syslog Enable the syslog settings using the Enable Syslog check box to forward
system wide logs to an external syslog server or to save to a storage device
such as a USB or SD card connected to the wireless controller. By default, the
syslog settings are disabled.
Log Level From the Log Level menu, select one of the following levels:
• LOG_LEVEL_CRIT. Critical errors only are logged.
• LOG_LEVEL_ERR. Noncritical errors and critical errors are logged.
• LOG_LEVEL_WARN. Warnings, noncritical errors, and critical errors are
logged.
• LOG_LEVEL_NOTICE. Notifications, warnings, noncritical errors, and
critical errors are logged.
• LOG_LEVEL_INFO. Informational messages, notifications, warnings,
noncritical errors, and critical errors are logged.
Syslog Location Select the External radio button if your network includes a syslog server.
Syslog Server IP Address Enter the IP address to which the wireless controller and managed access
points send all syslogs, if the Enable Syslog check box is selected.
Note: Before you configure the IP address of the syslog server on the wireless
controller, make sure that you set up a syslog server (such as a computer running
a syslog service) and that the syslog server is available on the network.
Server Port Number Enter the number of the port at which your syslog server is configured to listen to
requests.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English